Material Safety Data Sheet

SECTION I - Material Identity
SECTION II - Manufacturer's Information
SECTION III - Physical/Chemical Characteristics
SECTION IV - Fire and Explosion Hazard Data
SECTION V - Reactivity Data
SECTION VI - Health Hazard Data
SECTION VII - Precautions for Safe Handling and Use
SECTION VIII - Control Measures
SECTION IX - Label Data
SECTION X - Transportation Data
SECTION XI - Site Specific/Reporting Information
SECTION XII - Ingredients/Identity Information

SECTION I - Material Identity
Item Name                               
Part Number/Trade Name                   X-CEL NON-DETERGENT 30WT MOTOR OIL
National Stock Number                    9150P301302F
CAGE Code                                KEMCO
Part Number Indicator                    A
MSDS Number                              179803
HAZ Code                                 B

SECTION II - Manufacturer's Information
Manufacturer Name                        KEMCO OIL & CHEMICALS
Street                                   1374 E. MAIN ST
City                                     LEHI
State                                    UT
Country                                  US
Zip Code                                 84043
Emergency Phone                          800-284-5323
Information Phone                        801-768-4408

MSDS Preparer's Information
Date MSDS Prepared/Revised               NONE
Active Indicator                         N

Alternate Vendors

SECTION III - Physical/Chemical Characteristics
Appearance/Odor                          AMBER LIQUIED.SLIGHT HYDROCARBON ODOR
Boiling Point                            N/D
Vapor Pressure                           N/D
Vapor Density                            N/D
Specific Gravity                         .87
Evaporation Rate                         N/D
Container Pressure Code                  4
Temperature Code                         8
Product State Code                       L

SECTION IV - Fire and Explosion Hazard Data
Flash Point Method                       COC
Extinguishing Media                      CO2,DRY CHEMICAL,FOAM,WATER FOG.WATER MAY BE INEFFECTIVE IN FIGHTING AN OIL FIRE UNLESS USED BY EXPERIENCED FIRE FIGHTES
Special Fire Fighting Procedures         NO SPECIAL PROCEDURE FOR SMALL FIRES.LARGE STORAGE FIRES:DO NOT ENTER ANY ENCLOSED OR CONFINED SPACE WITHOUT FULL PROTECTIVE EQUIP/SCBA
Unusual Fire/Explosion Hazards           CONTAINERS MAY BURST WHEN EXPOSED TO FIRE CONDITIONS 

SECTION V - Reactivity Data
Stability                                YES
Stability Conditions to Avoid            HIGH TEMPERATURES AND OPEN FLAMES 
Materials to Avoid                       STRONG OXIDIZING AGENTS 
Hazardous Decomposition Products         CO2,WATER VAPOR.MAY PRODUCE OXIDES OF SULPER,NITROGEN,AND PHOSPHOURS.INCOMPLETE COMBUSTION CAN PRODUCE CO 
Hazardous Polymerization                 NO
Polymerization Conditions to Avoid       NONE KNOWN

SECTION VI - Health Hazard Data
Route of Entry: Skin                     NO
Route of Entry: Ingestion                NO
Route of Entry: Inhalation               NO
Health Hazards - Acute and Chronic       NONE KNOWN
Symptoms of Overexposure                 INGEST:NOT EXPECTED TO BE ACUTELY TOXIC.MAY CAUSE NAUSEA AND DIARRHEA.SKIN:NOT EXPECTED TO CAUSE MORE THAN MINOR IRRITATION FOLLOWING PROLONGED AND/OR REPEATED CONTACT.EYE:MAY CAUSE MONOR IRRITATION.INHALE:NOT EXPECTED TO BE TOXIC.BREATHING MINERAL OIL MISTS AT LEVERLS >TVL MAY CAUSE RESPIRATORY IRRITATION/DISCOMFORT
Emergency/First Aid Procedures           INGEST:DO NOT INDUCE VOMITHING.CALL PHYSICIAN.SKIN:WASK W/SOAP/WATER.LAUNDER SOILED CLOTHING.INHALE:UNLIKELY;IF RESPIRATORY DISCOMFORTOR IRRITATION OCCURES,MOVE TO FRESH AIR.IF SYMPTOMS CONTINUE,CONTACT A PHYSICIAN.EYE:FLUSH W/WATER FOR 15MIN.IF IRRITATION CONTUNUES,CALL PHYSICIAN 

SECTION VII - Precautions for Safe Handling and Use
Steps if Material Released/Spilled       CLEAN UP SPILLS AS SOON AS POSSIBLE.ABSORB LARGE SPILLS W/COMMERCIALLY AVAILABLE ABSORBENT MATERIALS,SUCH AS ABSORBENT CLAY 
Waste Disposal Method                    PLACE CONTAMINATED MATERIAL IN DISPOSABEL CONTAINERS AND BURY IN AN APPROVED LANDILL SITE PER LOCAL, STATE, AND FEDERAL REGULATIONS 
Handling and Storage Precautions         DO NOT STORE NEAR HIGH HEAT OR OPEN FLAME
Other Precautions                        AVOID PROLONGED/REPEATED SKIN CONTACT.GOOD PERSONAL HYGIENE IS ESSENTIAL 

SECTION VIII - Control Measures
Respiratory Protection                   NOT APPLICABLE FOR INTENDED USE.IF UNUSUAL OPERATING CONDITIONS CREATE CONCENTRATIONS IN EXCESS OF THE TVL,AND APPROVED RESPIRATOR IS RECOMMENDED 
Ventilation                              NONE NEEDED FOR INTENDED USE 
Protective Gloves                        IMPERVIOUS
Eye Protection                           NONE NORMALLY REQUIRED
Other Protective Equipment               NONE NORMALLY NECESSARY FOR INTENDED USE
Work Hygenic Practices                   WASH THOROUGHLY AFTER USE,ESPECIALLY BEFORE EATING/SMOKING
Disposal Code                            O

SECTION IX - Label Data
Protect Eye                              NO
Protect Skin                             YES
Protect Respiratory                      NO
Chronic Indicator                        UNKNOWN
Contact Code                             SLIGHT
Fire Code                                UNKNOWN
Health Code                              UNKNOWN
React Code                               UNKNOWN
Specific Hazard and Precaution           NOTE TO PHYSICIAN:USED MOTOR OILS HAVE BEEN SHOWN TO CAUSE SKIN CANCER IN MICE FOLLOWING REPEATED APPLICATION AND CONTINUOUS EXPOSURE.BRIEF OR INTERMITTENT SKIN CONTACT W/USED OIL IS NOT EXPECTED TO HAVE SERIOUS EFFECTS IN HUMANS IF THE OIL IS THOROUGHLY REMOVED BY WASHING W/SOAP/WATER 

SECTION X - Transportation Data
Container Quantity                       1
Unit of Measure                          QT

SECTION XI - Site Specific/Reporting Information
Volatile Organic Compounds (P/G)         0
Volatile Organic Compounds (G/L)         0

SECTION XII - Ingredients/Identity Information
Ingredient #                             01
Ingredient Name                          MATERIAL OILS (MIXTURE)
CAS Number                               1003
Proprietary                              NO
Percent                                  90
ACGIH TLV                                5MG/M3