| Stability |
YES |
| Stability Conditions to Avoid |
EXCESSIVE HEAT |
| Materials to Avoid |
UNCONTROLLED EXPOSURE TO STRONG OXIDIZING AGENTS,ACIDS, MERCAPTANS, BASES OR AMINES ESPECIALLY IN QNTY > 1 LB |
| Hazardous Decomposition Products |
THERMAL - CARBON DIOXIDE,CARBON MONOXIDE,ALDEHYDES AND OTHER HAZARDOUS ORGANICS |
| Hazardous Polymerization |
NO |
| Polymerization Conditions to Avoid |
WILL NOT ORDINARILY OCCUR |
| LD50 - LD50 Mixture |
N/K |
| Route of Entry: Skin |
NO |
| Route of Entry: Ingestion |
YES |
| Route of Entry: Inhalation |
YES |
| Health Hazards - Acute and Chronic |
[INGEST] SINGLE DOSE TOXICITY IS LOW. ORAL LD30 FOR RATS IS >4000 MG/KG. NO HAZARDS ANTICIPATED FROM INGESTION INCIDENTAL TO INDUSTRIAL EXPOSURE. [INHAL] AT AMBIENT CONDITIONS VAPORS ARE UNLIKELY TO CAUSE HARM. MODERATE HEATING CAN GENERATE VAPORS THAT COULD CAUSE RESPIRATORY IRRITATION IF INHALED. [SKIN] MAY CAUSE ALLERGIC SKIN REACTION (REDDENING AND SWELLING). SENSITIZER MAY CAUSE ALLERGIC REACTION IN CERTAIN INDIVIDUALS. PROLONGED EXPOSURE IS NOT LIKELY TO CAUSE SIGNIFICANT SKIN IRRITATION |
| Carcinogenity: NTP |
NO |
| Carcinogenity: IARC |
NO |
| Carcinogenity: OSHA |
NO |
| Explanation of Carcinogenity |
NONE |
| Symptoms of Overexposure |
SEE ABVOE AND [SKIN CONTINUED] ALTHOUGH REPEATED EXPOSURE MAY. NOT LIKELY TO BE ABSORBED THROUGH THE SKIN IN HARMFUL AMOUNTS. [EYE] MAY CAUSE SLIGHT TRANSIENT (TENPORARY) EYE IRRITATION. CORNEAL INJURY IS UNLIKELY |
| Medical Cond. Aggrevated by Exposure |
NR |
| Emergency/First Aid Procedures |
[EYE] IMMEDIATELY FLUSH WITH LARGE AMOUNTS OF WATER FOR AT LEAST 10 MIN. CONTACT A PHYSICIAN IMMEDIATELY. [SKIN] WIPE OFF EXCESS WITH TOWEL AND IMMEDIATELY WASH THOROUGHLY WITH SOAP AND WATER. [INHAL] MOVE TO FRESH AIR IF SYMPTOMS OCCUR. CONSULT PHYSICIAN. [INGEST] CALL A PHYSICIAN OR POISON CONTROL CENTER IMMEDIATELY. NO SPECIFIC ANTIDOTE. TREATMENT BASED ON JUDGMENT OF THE PHYSICIAN IN RESPOSE TO THE REACTIONS OF THE PATIENT |
| Steps if Material Released/Spilled |
OBSERVE ALL PRECAUTIONS. ELIMINATE ALL IGNITION SOURCES. WEAR SCBA (FP A) & OTHER PROT EQUIP. [LARGE] DIKE AND PUMP INTO APPROPRIATE CONTAINERS. [SMALL] SOAK UP IN AN INERT ABSORBENT MATERIAL (SAND, VERMICULITE, ETC). RESIDUAL RESIN MAY BE REMOVED USING HOT SOAPY WATER. PLACE WASTE IN A US DOT APPROVED METAL CONTAINERS AND SEAL |
| Neutralizing Agent |
NR |
| Waste Disposal Method |
INCINERATION OF THE PRODUCT AT A US EPA PERMITTED WASTE FACILITY AND OR BURIAL IN AN EPA SECURED LANDFILL. OTHER APPLICABLE FEDERAL, STATE AND LOCAL REGULATIONS SHOULD ALSO BE OBSERVED |
| Handling and Storage Precautions |
STORE AT 80F OR BELOW. AVOID EYE AND SKIN CONTACT. DO NOT WEAR CONTACT LENSES WHILE USING OR IN THE VICINITY IN WHICH IT IS BEING USED. CLOTHING SHOULD BE WASHED BEFORE REUSING. SEVERELY CONTAMINATED CLOTHING SHOULD BE DISCARDED. FOR CURED MATERIAL AVOID BREATHING DUST ESPECIALLY DURING GRINDING, |
| Other Precautions |
NR |
| Respiratory Protection |
WEAR A NIOSH APPROVED PARTICULATE RESPIRATOR DURING CUTTING/GRINDING OPERATIONS OF CURED MATERIAL |
| Ventilation |
VENT CURING OVENS OUTDOORS. GOOD GENERAL VENTILATION SHOULD BE SUFFICIENT FOR MOST CONDITIONS |
| Protective Gloves |
IMPERVIOUS LATEX OR RUBBER GLOVES |
| Eye Protection |
SAFETY GLASSES OR GOGGLES |
| Other Protective Equipment |
FOR BRIEF CONTACT NO SPECIAL EQUIP |
| Work Hygenic Practices |
WASH THOROUGHLY AFTER HANDLING |
| Supplemental Health/Safety Data |
STORE AT 80F OR BELOW. AVOID EYE AND SKIN CONTACT. DO NOT WEAR CONTACT LENSES WHILE USING OR IN THE VICINITY IN WHICH IT IS BEING USED. CLOTHING SHOULD BE WASHED BEFORE REUSING. SEVERELY CONTAMINATED CLOTHING SHOULD BE DISCARDED. FOR CURED MATERIAL AVOID BREATHING DUST ESPECIALLY DURING GRINDING/CUTTING OPERATIONS |
