| Item Name | |
| Part Number/Trade Name | 295-100 WHITE UNI-PRIME PRIMER |
| National Stock Number | 8010P295-100 |
| CAGE Code | 1K0U6 |
| Part Number Indicator | A |
| MSDS Number | 192389 |
| HAZ Code | B |
| Manufacturer Name | KELLY-MOORE PAINT COMPANY, INC |
| Street | 987 COMMERCIAL STREET |
| City | SAN CARLOS |
| State | CA |
| Country | US |
| Zip Code | 94070 |
| Emergency Phone | 800-424-9300 CHEMTREC |
| Information Phone | 680-592-8337 |
| Date MSDS Prepared/Revised | 19JUN98 |
| Active Indicator | Y |
| Appearance/Odor | WHITE PAINT (PRIMER) |
| Boiling Point | 212 F |
| Melting Point | NR |
| Vapor Density | < AIR |
| Specific Gravity | 1.4380 |
| Evaporation Rate | < ETHER |
| Solubility in Water | NR |
| Percent Volatiles by Volume | 64-66% |
| Container Type | R |
| Container Pressure Code | 1 |
| Temperature Code | 4 |
| Product State Code | L |
| Flash Point Method | UNK |
| Lower Explosion Limit | NA |
| Upper Explosion Limit | NA |
| Extinguishing Media | NA |
| Special Fire Fighting Procedures | NONE |
| Unusual Fire/Explosion Hazards | NR |
| Stability | N/K |
| Stability Conditions to Avoid | STABLE |
| Materials to Avoid | STRONG OXIDIZING AGENTS |
| Hazardous Decomposition Products | MAY PRODUCE HAZARDOUS FUMES WHEN HEATED TO DECOMPOSITION AS IN WELDING |
| Hazardous Polymerization | NO |
| Polymerization Conditions to Avoid | WILL NOT OCCUR |
| Route of Entry: Skin | YES |
| Route of Entry: Ingestion | YES |
| Route of Entry: Inhalation | YES |
| Health Hazards - Acute and Chronic | DIZZINESS, HEADACHE, NAUSEA, CONFUSION, IRRITATION TO UPPER RESPIRATORY TRACT, SKIN & EYE IRRITATION |
| Symptoms of Overexposure | SEE ABOVE |
| Medical Cond. Aggrevated by Exposure | NONE KNOWN |
| Emergency/First Aid Procedures | [INHAL] REMOVE TO FRESH AIR. RESTORE BREATHING. CONSULT PHYSICIAN. [EYE] FLUSH WITH LARGE VOLUMES OF WATER FIR 15 MIN. GET MED ATTEN. [SKIN] WIPE OFF WITH A RAG. WASH THOROUGHLY WITH SOAP AND WATER. [INGEST] CONSULT HOSPITAL EMERGENCY ROOM OR POISON CONTROL CENTER IMMEDIATELY |
| Steps if Material Released/Spilled | VENTILATE AREA TO PREVENT BUILD-UP OF VAPORS. FOR SMALL SPILLS, SOAK UP WITH ABSORBENT. FOR LARGE SPILLS DIKE AREA WITH ABSORBENT MATERIAL AND SCOOP UP LIQUID |
| Waste Disposal Method | DISCARD IN LANDFILL IN SEALED CONTAINERS AWAY FROM HEAT AND FLAME AND IN ACCORDANCE WITH LOCAL REGULATIONS |
| Handling and Storage Precautions | STORE UPRIGHT IN SEALED CONTAINERS AWAY FROM HEAT AND FLAME |
| Other Precautions | THIS PRODUCT CONTAINS PIGMENTS WHICH LIKE MOST NATURALLY OCCURING MINERALS CONTAIN SMALL AMOUNTS OF CRYSTALLINE SILICA. THIS PRESENTS NO HAZARD WHEN APPLYING THE COATING, BUT SANDING UT WUKK, |
| Respiratory Protection | USE A PARTICLE MASK (NIOSH/MSHA TC-21C) TO AVOID BREATHING SPRAY MIST OR SANDING DUST IF LOCAL VENTILATION IS INADEQUATE TO KEEP |
| Ventilation | LOCAL CROSS VENTILATION OR MECHANICAL EXHAUST SUFFICIENT TO KEEP ALL HAZARDS CONCENTRATIONS BELOW PRESCRIBED |
| Protective Gloves | RECOMMENDED |
| Eye Protection | GLASSES WITH SIDE SHIELDS OR GOGGLES |
| Other Protective Equipment | NR |
| Work Hygenic Practices | WASH THOROUGHLY AFTER HANDLING |
| Protect Eye | NO |
| Protect Skin | NO |
| Protect Respiratory | NO |
| Chronic Indicator | UNKNOWN |
| Contact Code | UNKNOWN |
| Fire Code | UNKNOWN |
| Health Code | UNKNOWN |
| React Code | UNKNOWN |
| Volatile Organic Compounds (P/G) | 2.0861 |
| Volatile Organic Compounds (G/L) | 249.9958 |
| Ingredient # | 01 |
| Ingredient Name | PROPANOIC ACID, 2-METHYL-, MONOESTER WITH 2,2,4-TRIMETHYL-1,3-PENTANEDIOL (<3%) |
| CAS Number | 25265774 |
| Proprietary | NO |
| Percent | 3 |
| Ingredient # | 02 |
| Ingredient Name | 2-PROPANOL, 1-(2-BUTOXY-1-METHYLETHOXY)- (<3%) |
| CAS Number | 29911282 |
| Proprietary | NO |
| Percent | 3 |